Due to the types of gaskets, bearings, bowls and packs of the whole engine with different length and volume expansions, they should be sealed at low speeds early on.
Sealing is not just specific to the engine, and the gearboxes are also very sensitive. Due to metal contact with metal in gearbox and bearings in other moving parts, sealing is necessary.
In prestigious cars, the parts are completely aligned with each other before being installed and are thus separately sealed and then put together. From the beginning, the driver can drive quickly and easily, but most of the vehicles are delivered with new and uncrowned parts.
Automotive experts say different parts, such as pistons, paints and other parts, should be co-ordinated and integrated with the proper functioning and optimal lubrication. Sometimes, due to the heterogeneity of parts of a car, these parts must be coordinated. It is better to drive the car in the first thousand kilometers before entering the car as much as possible. Therefore, it should be used on the uphill of a heavy gear. An appropriate acceleration before getting to the top is a good way to prevent pressure from entering the car. It's better to use less engine speed and a lighter gear during this period. There are limits to using the gas pedal and any gutter is forbidden by the car. Some shoppers will replace rims after buying a zero-rider car, which damages the car's chassis without an expert opinion. Engine oils and filters must be replaced after the first thousand kilometers.
How should we seal our car?
To do this, you should put a little pressure on the first 1,000 km of the car. This means that you try to travel with the maximum number of occupants with the car to the extreme, and use a heavy gear at the top not to push the engine. The proper acceleration before going to the top can also prevent the vehicle from coming into contact with the engine. During the sealing and during the movement, it is important to ensure that the engine speed does not exceed half the maximum engine speed possible. The maximum permitted engine speed of each vehicle is also indicated by the red on the counter of the engine counter. Remember that gears 1 and 2 are only for starting to move or continue at low speeds. Insisting on using these two gears at higher speeds can both push the engine and damage it during the sealing process. So whatever you can do with less engine speed and lighter gear. During this time, you should also be careful about using the gas pedal and refueling the car's gasket. Pulling, sudden brakes and rapid circumvention that put the weight on one side are among the things that should be avoided during sealing. Try to avoid spraying the car or throwing the rims on the tires during this period, because the rims themselves, which are often installed without any expert advice on the car, cause significant damage to the chassis. After the end of the first thousand kilometers, the engine oil, along with its filter, must be replaced, in order to remove cylindrical cuttings from inside it. Keep in mind, the only factor at high speed can cause damage to the vehicle at the time of sealing is, the greater the engine speed and should as far as possible from rising too much to prevent it, and have it to remember Depreciation of the car is directly related to the pressure you enter into the engine.